Mounting Instructions
Step 1
The Set-Up
The box already contains screws, wall anchors and a pencil
The only tools required are a drill, a 6mm drill bit, a level, and a T25 Torx screwdriver
Step 2
Mark the wall for the first hole
Utilize the supplied pencil to create a distinct mark on the wall to indicate the drilling location
Note: Ensure the club holder is high enough to support your tallest club
step 3
Drill the first hole
Using a 6mm bit, dirll the first hole in the wall
step 4
Tighten the first screw slightly
Secure the wall anchor and carefully tighten the first screw. The club holder should be positioned vertically
Note: The stainless steel screws supplied are of excellent quality and appearance. However, avoid over-tightening the screws
Step 5
Drill the second hole through the club holder
With the 6mm bit and a level, drill the start of the second hole through the club holder. Place the club holder vertically and complete drilling the hole
STEP 6
Tighten the second screw
Mount the second wall anchor and rotate the club holder to a horizontal position. Softly fasten the 2 screws
Get ready to tee off with your new Golf Accessory!
We wish you many enjoyable years with your new Tanamon Golf club holder